Frymaster SINBAD II Manuel d'utilisateur

Frymaster, a member of the Commercial Food Equipment Service Association, recommendsusing CFESA Certified Technicians.819-587424-Hour Service Hotline

2-4The indicator light in the selector will illuminate and the drum will begin to rotate, transferring fries from the hopper to the dispensing chute

2-5NOTE: If you do not begin pressing Selector 1 within 5 seconds after entering the PROGRAMMING mode, the unit will automatically return to the ST

SinBaD II SINGLE BASKET DISPENSER CHAPTER 3: MAINTENANCE & OPERATOR TROUBLESHOOTING 3-1 3.1 Cleaning and Maintenance Routine cleaning in acco

3-2 PROBLEM Probable Causes Corrective Action A. ON/OFF rocker switch is in OFF position. A. Place rocker switch in the ON position. B. Unit is

3-3 PROBLEM Probable Causes Corrective Action Continued from previous page. B2. The minimum weight that should be programmed is .38 lbs. (.17kg).

3-4 PROBLEM Probable Causes Corrective Action A. Operator error. A. Batch weight selector “1” must be pressed four consecutive times within 5 se

THIS PAGE INTENTIONALLY LEFT BLANK

Frymaster, L.L.C., 8700 Line Avenue, PO Box 51000, Shreveport, Louisiana 71135-1000Shipping Address: 8700 Line Avenue, Shreveport, Louisiana 71106T

DANGER IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION, SERVICE, OR MAINTENANCE CAN CAUSE PROPERTY DAMAGE, INJURY, OR DEATH. READ THE INSTALLATION, O

SinBaD II SINGLE BASKET DISPENSER TABLE OF CONTENTS i CHAPTER 1: General Information 1.1 Parts Ordering and Service Information...

SinBaD II SINGLE BASKET DISPENSER CHAPTER 1: GENERAL INFORMATION 1-1 1.1 Parts Ordering and Service Information In order to assist you as quickly

1-2 1.3 Equipment Description The SinBaD II Single Basket Dispenser is designed to dispense french fries in batches of consistent weight into standa

1-3 A list of Factory Authorized Service Centers (FASCs) is included with your unit when shipped from the factory. Failure to use qualified service

SinBaD II SINGLE BASKET DISPENSER CHAPTER 2: INSTALLATION AND OPERATION 2-1FINDING YOUR WAY AROUND YOUR NEW SinBaD UNIT Load Cell Arms (behind fr

2-22.1 Installation DANGER All electrically operated appliances must be electrically grounded in accordance with local codes, or in the absence of

2-32.3 Operation CAUTION Ensure the ON/OFF Rocker Switch is in the OFF position before installing the hopper. 1. Verify that the ON/OFF Rocker S