Frymaster 14 Series Manuel d'utilisateur télécharger pdf (Page 60)

5-1

BIELA14 SERIES LOV™ ELECTRIC FRYER

CHAPTER 5: FILTRATION INSTRUCTIONS

5.1 Introduction

The FootPrint Pro filtration system allows the oil in one frypot to be safely and efficiently filtered

while the other frypots in a battery remain in operation.

Section 5.2 covers preparation of the filter system for use. Operation of the system is covered in

Section 5.3.

WARNING

The on-site supervisor is responsible for ensuring that operators are made aware of

the inherent hazards of operating a hot oil filtering system, particularly the aspects

of oil filtration, draining and cleaning procedures.

WARNING

The filter pad or paper MUST be replaced daily.

5.2 Preparing the Filter for Use

1. Pull the filter pan out from the cabinet

and remove the crumb tray, hold-down

ring, filter pad (or paper), and filter

screen. (See Figure 1) Clean all metal

parts with a solution of All Purpose

Concentrate and hot water then dry

thoroughly.

The pan cover must not be removed

except for cleaning, interior access, or to

allow a shortening disposal unit

(MSDU) to be positioned under the

drain. If using an MSDU built before

January 2004 see instructions on page 4-

16.

2. Inspect the filter pan connection fitting

to ensure that both O-rings are in good

condition. (See Figure 2)

Figure 1

Figure 2

Inspect the filter

connection fitting

O-rings.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 77 78

Pas de commentaire

Frymaster 14 Series Manuel d'utilisateur Page 60